TOOL OPERATION
Always check the tool first to make sure
that it does not contain a fastener. If the
tool contains a fastener from a previous
application, remove both the battery and
the fuel cell before attempting to remove
the fastener.
Operating the T3 Tool
1. Insert a charged battery into the tool
with the battery clip toward the rear of
the tool.
2. Insert the Ramset fuel cell into the tool
as described on page 6.
3. Pull the magazine follower back to the
locking position.
4. Insert the nail strips into the opening in
the back of the magazine.
5. Slightly pull back on the magazine
follower while pressing the button
at the back of the follower. This will
release the follower making contact
with the back of the last pin strip.
6. Place the tool in the spot where you
want to make the fastening.
7. With the tool in position and perpen-
dicular to the work surface; press
down on the tool.
8. Note that the fan motor is running and
the LED light on the side of the handle
is a solid green color indicating the tool
is ready to make a fastening.
9. Pull the trigger to make the fastening.
10. The tool is ready for the next fastening.
To avoid overheating the tool do not
hold your hand over the air intake
section on the top end of the tool.
Removing The Fastener Magazine
On occasion the fastener magazine may
need to be removed to clear a fastener
jam. To do so, unscrew the knob at the
rear of the tool. Then press the knob. Slide
the magazine rearward to remove it from
the tool.
Insert battery
Insert fuel cell
Insert fastener
Knob
Hold tool
perpendicular
in contact with
work surface
T3 MAGAZINE TOOL OPERATING INSTRUCTIONS
T3 MAGAZINE TOOL OPERATING INSTRUCTIONS
12
90°
