T3SS TOOL OPERATING INSTRUCTIONS
T3SS TOOL OPERATING INSTRUCTIONS
10
TOOL OPERATION
Always check the tool first to make sure that
it does not contain a fastener. If the tool
contains a fastener from a previous application,
remove both the battery and the fuel cell
before attempting to remove the fastener.
Operating the T3SS Tool
1. Insert a charged battery into the tool
with the battery contacts to the front.
2. Insert a good fuel cell into the tool as
described on page 9.
3. With your finger off the trigger, insert
the fastener you wish to use in the
nose of the tool. Do not force the
fastener into the tool such that you
cause the work contact element to
be pushed up into the tool body.
4. Note that the LED light on the side
of the handle is a flashing green
indicating the the tool is now ready
to make a fastening.
5. Place the tool in the spot where
you want to make your fastening.
6. With the tool in place and the supporting
foot in contact with the work surface,
hold the tool perpendicular compress
the nose against the work surface and
pull the trigger to make the fastening.
7. The tool is now ready for the next
fastener.
To avoid overheating the tool, do not
completely close off the air intake section
on the top end of the tool.
Removal of Rear Foot Assembly
1. Find the knob on the rear of the tool,
turn the knob counter clockwise until
it stops
2. Push the knob inward
3. Push the foot back, off of the
handle assembly
4. Reverse the above procedure
for installation
Insert battery
Insert fuel cell
Insert fastener
Hold tool perpendicular
In contact with work surface
90°
