TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
4.
With the barrel fully open, and the
receiver clear, insert a powder load
into the chamber and close the tool
to the semi-closed position.
Never
attempt to close the tool by exerting
force on the front end of the barrel.
Never place your hand, fingers
or any other body part over the
fastener loading end of the tool.
5.
Hold the tool perpendicular (90°) to
the work surface with both hands
and press firmly to fully depress the
tool. Maintain firm downward
pressure on the tool with both
hands and pull the trigger to drive
the fastener.
DO NOT DEPRESS
THE TOOL AGAINST ANYTHING
OTHER THAN THE INTENDED
WORK SURFACE.
Holding the tool
firmly in place will produce more
consistent fastening quality and
minimize tool wear or damage.
6.
After making the fastening, point the
tool in a safe direction, snap the
barrel forward and twist the handle
to allow the fired load to fall out of
the tool.Should a fired load fail to
eject, open and close the barrel
several times to loosen the load in
the chamber, then remove the load
with your fingers.
Never attempt to
pry an unfired load out of the
tool chamber.
The
load could be
caused to discharge resulting in a
serious injury or death to the tool
operator or to a bystander.
7.
Insert another fastener in the
muzzle end of the tool as before
and insert a new powder load into
the chamber.
Always insert the
fastener into the tool before
inserting the powder load.
Keep
your finger off of the trigger until the
tool is in position to drive the
fastener.
Never carelessly discard
or throw unfired powder loads
into a trash container.
CLOSE TOOL TO THE
SEMI-CLOSED POSITION
OPEN AND TWIST TO EJECT
THE FIRED LOAD
HOLD TOOL PERPENDICULAR
INSERT POWDER LOAD INTO
THE CHAMBER
