FASTENERS / LOADS
FASTENERS / LOADS
7
Your Ramset D45 tool uses only the Ramset fasteners and loads shown
below or listed for the tool in the Product Catalog.
DANGER
.300 HEAD PLASTIC FLUTED DRIVE PINS
.300 HEAD PLASTIC FLUTED DRIVE
PINS WITH 7/8" WASHER
1/4"-20 Threaded studs
.300 HEAD TOP-HAT DRIVE PINS
.300 HEAD POWER POINT
PLASTIC FLUTED DRIVE PINS
CONDUIT CLIP ASEMBLIES
For 1/2" and 3/4” Diameter Conduit with
1" premounted fastener
CEILING CLIP ASSEMBLIES
Ceiling Clip with 1" or 1-1/4" premounted
.145 shank pin and Ceiling Clip with 1" or
1-1/4" premounted .150/.180 shank pin.
Never use any other types of fasteners or disc loads in the D45 tool.
Use of other types of fasteners or loads may cause unintentional load discharge,
damage the tool, cause poor fastening performance, or create a risk of seroius
injury to the operator or bystanders.
FASTENERS
.145 Shank Diameter in Shank lengths from
1/2” to 2 ”
.145 Shank Diameter in Shank Lengths from
1” to 2 1/2”
.145 Shank Diameter in Shank Lengths of
1/2” and 1” and thread lengths of 1/2”,
3/4” and 1”
.150 Straight Shank in Shank Lengths from
1/2” to 7/8”
.150 / .180 Step Shank in Lengths from
1” to 1 7/8”
.145 Shank Diameter in Shank Lengths from
1/2” to 1”
LOADS
D60/45 DISC LOAD
POWER CATALOG LOAD
CASE
LEVEL
NUMBER COLOR COLOR
2
2D60/45
Brown
Brass
3
3D60/45
Green
Brass
4
4D60/45
Yellow
Brass
5
5D60/45
Red
Brass
The power level of the loads is indicated by
the number marked on each box, the color of
the box and the color on the tip of each load.
As the number increases, the power level
also increases.
Always perform the center punch test
described on page 3 to test the base
material.
Always make a test fastening using the # 2,
Brown, power level first. If more power is
required to set the fastener, use the next
higher power level until the power level
necessary to drive the fastener is reached.
Ramset D60/45 disc loads are specially made for use in the D45 Tool.
