III - OPERATION
12
MOUNTING ATTACHMENTS
INSTALLATION OF ATTACHMENT
1.
Rotate Lock Pins to the unlock
position (handle pointing
outwards).
2.
Tilt the attachment frame forward
as shown in Figure 7, so that the
top round edge of the
attachment frame will fit under
the lip of the attachment.
3.
Drive into the attachment, raising
the arms so that the top of the
attachment frame slips under the
lip on the attachment, and
attachment lifts slightly.
4.
Using the tilt cylinder, roll back
the attachment so it drops into
place, as shown in Figure 8
5.
Rotate the lock pins to the locked
position (handles facing
inwards), and check that the lock
pins are fully inserted through the
lock holes in the attachment.
6.
Connect attachment hydraulic
hoses
(if required) to the quick
couplers as shown in Figure 9.
REMOVAL OF ATTACHMENT
1.
Lower lift arms and tilt forward on
the attachment so that the
attachment is resting on the
ground.
2.
If attachment is hydraulically
equipped, stop the engine,
relieve hydraulic pressure in the
attachment lines by shifting the
auxiliary lever back and forth,
and disconnect the attachment.
3.
Rotate the lock pins to the
unlocked (handles pointing
outwards) position.
4.
Start engine, tilt the attachment
mount frame clears that lip on the
attachment, and back the Mini-
Skid away from the attachment.
WARNING
After Hook-Up to Attachment, Check
to be Sure Lock Pins are Fully
Engaged, and Locked Into Position.
Figure 7
Figure 8
Figure 9
