9
SM-ECXCABLE Rev B
Installation Instruction and Care
The ECX-110 & ECX-240 power extension cables are fully assembled and ready for use upon receipt. No post assembly
required.
1.
Completely uncoil power extension cable as to be used between AC power source and electrical device.
2.
Inspect cable and connectors for damage or wear that could render the cable unsafe for hazardous locations.
3.
Route cable to avoid contact with heavy machinery that could possibly damage cable or possible be a trip hazard
for workers. Cables must be integrated into a system in a way to support accessibility for regular maintenance.
4.
Connect plug end of the power extension cable to the AC power source.
5.
Verify AC power source is providing an electrical ground connection.
6.
Verify electrical device is turned OFF before attaching power extension cable.
7.
Connect coupler end of cable to the electrical device.
The power extensions shall be installed, so far as is practicable, in positions that will prevent them being exposed to
mechanical damage, to corrosion or chemical influences (for example solvents), to the effects of heat and to the effects
of UV radiation.
These are the minimum allowed bend radii for the cables. 1.5mm²:
≥
4in, 2.5mm²
≥
5.5in, 4.0mm²
≥
6.2in.
The bend radius of the cable should start at least 25mm from the end of the cable.
Note:
For ATX connectors lift dust covers and insert plug into coupler until coupler dust cap latches snaps into position
on plug. To break connection between coupler and plug lift dust cap to pull connectors apart.
Note:
For CEAG connectors lift dust cover, insert plug into coupler, and rotate clockwise, to lock plug into coupler and
to close power switch within the coupler. To break connection between coupler and plug lift dust cap and rotate plug
counterclockwise to pull connectors apart.
Note:
For R. STAHL connectors insert plug into coupler and rotate outer ring clockwise to secure plug to coupler.
A.T.X. Connector Installation and Removal
A.T.X: Plug to Socket & Coupler Compatible Table
VOLTAGE
PLUG
WALL SOCKETS
COUPLER
100 / 130V
PRE316PY
PRE316RY
PRE316MY
PRE316FY
200 / 250V
PRE316PB
PRE316RB
PRE316MB
PRE316FB
Plug
removal
Plug
insertion
Summary of Contents for ECX-110
