11
are on, 1 being the slowest and least powerful and 5 being the fastest and most power. If on Pedal Assist level 0 the
thumb throttle will not have any power.
Walk Assist:
By holding down on the
“–”
button your bike will enter walk assist mode, the bike will propel itself as you walk along
side of it. Make sure your rear gears are on a larger sprocket to ensure the bike moves at a slower speed.
Speed Sensor:
Your bike is equipped with a speed sensor, the sensor consists of a sensor and a magnet. The sensor is mounted on the
frame near the rear tire and the magnet is attached to a spoke on the rear wheel. Every time the rear wheel makes a
revolution the magnet trips the sensor and signals to the LCD that the bike is in motion. It is very important that the
magnet on the spoke is properly aligned to the sensor. The magnet is the shiny part of the sensor and not the flathead
screwdriver side. The magnet should face the square (box) area of the sensor, not the circle part that is used to attach to
the frame.
USB Charging:
Your Bike is equipped with USB charging while the bike is turned on. You can charge devices such as cell phones, and
other devices that use USB charging cables. Locating your USB port; most USB ports are located at the bottom of the LCD
screen, while Megatron and Krusader models are located at the bottom of the power off/on switch.
Dual Battery Technology:
With the battery installed from the bottom of your bike frame, you can install a secondary battery on the top of your
bike frame. The additional battery is a 48v 14ah battery. Contact Rambo Bikes for more information.
ASSEMBLY
Tools Required:
One (1) 15mm wrench
One (1) 5mm Allen wrench
Side cutting pliers
Air Pump
BEFORE DOING ANY WORK ON YOUR BIKE ALWAYS BE SURE TO REMOVE THE BATTERY
First remove the bike from the box and remove all protective packaging and zip ties using side cutting pliers.
BE SURE NOT TO CUT ANY ELECTICAL WIRES OR BRAKE CABLES.
Once the packaging material is removed from the bike, remove the Allen bolts from the handlebar clamp using
a 4mm Allen wrench. At this time be sure to turn the stem so it is facing forward. As shown below.
Summary of Contents for PURSUIT R750P-FF-GY
Page 9: ...9 IDENTIFYING BIKE PARTS...
Page 25: ...25...
