(A) Clip
(B) Fixing bracket
(C) Screw
You should insert a clip (A) into the holes which are located in each corner of the hob.
Place the fixing brackets (B) over each hole and clip, and then place a screw (C)
through the hole and fixing bracket (B). Tighten the screws slowly. IMPORTANT: Do
not tighten the screws fully.
Carefully turn the hob back over and then gently lower it into the aperture hole that
you have cut out.
On the underneath of the hob, locate the fixing brackets (B) and turn them so that they
locate on the underneath of the worktop and the hob.
Fully tighten the screws (C) to secure the hob into position.
Wiring to 220V AC outlet
The “Green / yellow” earth wire must be connected to the Earth marked in the AC
outlet circuit box, or the plug. It must be about 10 mm longer than the two Live
wires.
The “Black” & “Red” (L1 & L2) wires must be connected to the terminal marked
with letter (L / H). Make sure the voltage supplied between two Live terminals of
the AC source is 220V.
Do not connect one of these two L wires to the Neutral(usually White color wire) in
