UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink
®
replaces up to three hand-held transmitters that operate devices such
as garage door openers, motorized gates, lighting or home security systems. The
HomeLink
®
unit is powered by your vehicles 12 Volt battery.
• The HomeLink
®
buttons that are located in the overhead console or sunvisor
designate the three different HomeLink
®
channels.
• The HomeLink
®
indicator is located above the center button.
Before You Begin Programming HomeLink®
• Ensure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
• For efficient programming and accu-
rate transmission of the radio-frequency
signal, it is recommended that a new
battery be placed in the hand-held
transmitter of the device that is being
programmed to the HomeLink
®
system.
• Erase all channels before you begin
programming. To erase the channels, place the ignition switch into the ON/RUN
position, then press and hold the two outside HomeLink
®
buttons (I and III) for up to
20 seconds or until the red indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
®
for
the first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–
3515 or, on the Internet at www.HomeLink.com for information or assistance.
ELECTRONICS
80
Summary of Contents for RAM CV 2013
