RAM 2011 DAKOTA, User Manual

Page: 28 / 76

Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice Command button .
• (After the BEEP), say “transfer call”.
Changing The Volume
• Start a dialogue by pressing the Phone button , then adjust the volume
during a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a
comfortable level while the Uconnect™ system is speaking. Please note the
volume setting for Uconnect™ is different than the audio system.
NOTE: To access the tutorial, press the Uconnect™ hard-key. After the BEEP, say
“tutorial”. Press any hard-key/button or touch the display (Touch-Screen radio) to
cancel the tutorial.
WARNING!
• Any voice commanded system should be used only in safe driving
conditions following local laws and phone use. All attention should be
kept on the roadway ahead. Failure to do so may result in a collision
causing you and others to be severely injured or killed.
• In an emergency, to use Uconnect™ Phone, your mobile phone must be:
• turned on,
• paired to Uconnect™ Phone,
• and have network coverage.
Uconnect™ VOICE COMMAND
• The Uconnect™ Voice Command system allows you to control your AM, FM
radio, satellite radio, disc player, Uconnect™ Phone, a memo recorder, and
supported portable media devices. The Voice Command system also provides
limited capability to select and play music by artist, song, album, music,
genre, or playlist from your compatible iPod
® device (this capability is
available for Media Center 430/430N when connected to the USB port).
• When you press the Voice Command button located on the radio
faceplate or steering wheel, you will hear a beep. The beep is your signal to
give a command. If you do not say a command within a few seconds, the
system will present you with a list of options. If you ever wish to interrupt the
system while it lists options, press the Voice Command button
, listen
for the BEEP, and say your command.
ELECTRONICS
26