3
Electrical System Technical Manual
Elements that influence the riding range
4
Battery information
ATTENTION!
Only use the original charger. Use of another battery charger will void your warranty and may cause damage to the
battery, the electrical system of the bike or in the worst case cause a fire. Make sure that the voltage specifications
match with your local electricity network.
Please charge the battery before first use until the green LED lights up
Charger safety instructions
- Always charge the battery with an original charger and do not
use the charger for any other devices.
- Always charge the battery in a ventilated room.
- Disconnect the charger from the mains when it is not used.
- Avoid contact with water and moisture.
- Inspect the charger, cable and plug for damage before every
use.
- Do not touch with wet hands.
- Do not use the charger on flammable surfaces .
- Keep the charger away from children.
- Do not open the charger.
- Do not use the charger in direct sunlight and only charge
between 0°C and 50°C.
BL07 with switch button
- Short press the button battery power on (LED light turns off
after 5 sec, but battery output is still standby)
- Long press the button for 3 sec. (at LED light turn on condition)
battery power off
- When switched on the power will continue 12hours (output
standby status)
- After 12hours without output, the battery power will totally turns
off (No matter the battery is on or out of the bike)
8.8Ah
11Ah
13Ah
14.5Ah
CH02/CH05 charger (2A)
±5.2 h
±6.5 h
±7.7 h
±8.6 h
CH03 charger (4A)
±3.6 h
±4.5 h
±5,3 h
±5.9 h
Charging time
The charging time varies depending on battery capacity
and battery charger.
The table below contains some indicative figures.
Connect the charger to the charging socket.
The red light indicates that the battery
is connected and charging.
The green light indicates that the battery
is fully charged.
Charging procedures
Switch Button
LED light shows 5 bars
each. Each bar indicates
20% capacity
