Inputs
The ten inputs of the WAVMI “A-E” are represented by these buttons and correspond
directly to the lettered terminal blocks on the circuit board. Each can be set to, “Normal”,
“Ignore” or “Invert” by clicking on the tile.
Normal –
Used to select this input as the trigger for the map.
Ignore –
The state of an input set to “Ignore” for a particular map will not affect whether the
output action occurs or not.
Invert –
Use only when combined inputs are required.
Take the example map shown in Figure 4. This map has a very standard configuration, as a
single input is causing a single command to be outputted. The input is “A” so this is set to
normal and all other inputs are set to ignore.
Mapping options
The mapping options are used to define additional parameters that must be met for the
“Output action” to occur.
WAVMI
Manual Version 2.0.1
