RAK WisBlock RAK19016, Quick Start Manual

Page: 1 / 12

Documentation Center
RAK19016 Quick Start Guide
Prerequisite
What Do You Need?
Before going through each and every step on using the RAK19016 WisBlock 5-24V Power Slot Module, make sure
to prepare the necessary items listed below:
Hardware
RAK19016 WisBlock 5-24V Power Slot Module
Your choice of WisBlock Base board with Power Slot
Your choice of WisBlock Core
Li-Ion/LiPo battery
RAK5804
(Reprogramming of the WisBlock Core via USB of RAK5804)
Software
Arduino
Download and install the Arduino IDE .
To add the RAKwireless WisBlock Core boards to your Arduino Boards Manager, install the RAKwireless
Arduino BSP .
Product Configuration
Hardware Setup
RAK19016 should be attached to the power slot connector of WisBlock Base board with power slot. The 5 V to
24 V DC input voltage must be connected to the 3-pin screw terminal connector. The LiPo/Li-Ion battery can be
connected to the standard battery connector.
⚠
WARNING
RAK19016 only supports WisBlock Base boards with power slot. It is not compatible with all WisBlock
Base boards.
For more information about RAK19016, refer to the Datasheet .
RAK19016 Connection to WisBlock Base board with
Power Slot