RAK WisBlock RAK13007, Quick Start Manual

Page: 1 / 14

Documentation Center
RAK13007 Quick Start Guide
Prerequisite
What Do You Need?
Before going through each and every step on using the RAK13007 WisBlock module, make sure to prepare the
necessary items listed below:
Hardware
RAK13007 WisBlock Relay Module
Your choice of WisBlock Base
Your choice of WisBlock Core
USB Cable
Li-Ion/LiPo battery (optional)
Solar charger (optional)
Software
Download and install the ArduinoIDE .
To add the RAKwireless Core boards on your Arduino board, install the RAKwireless Arduino BSP. Follow the
steps in the
Github repo .
Product Configuration
Block Diagram
Figure 1: RAK13007 Block Diagram
The RAK13007 uses one relay to isolate the output of the MCU. The dielectric strength between coil and contacts
of a relay is 2500 V
DC
, 50/60 Hz 1 min.
⚠ WARNING
Figure 2: Safety Precaution
Hardware Setup