10
5.2
Installation modes
The ISCOM HT803G-V can be installed on a stable workbench or a wall.
Installing the ISCOM HT803G-V on the workbench is informal
because unpredictable events (such as collision or object falling)
may prevent the ISCOM HT803G-V from working properly or
even damage it. We recommend installing it on a wall.
Install the ISCOM HT803G-V on a wall as below:
Step 1
Choose a proper height of installation position so that you can easily
observe LEDs and connect the power supply.
Step 2
Knock two cement nails, with spacing of 110 mm (distance between two
wall-mount holes), into the wall. The diameter of a cement nail should
be smaller than that of the wall-mount hole (8 mm).
Step 3
Align wall-mount holes with knocked cement nails, and hang the device
on nails. The device is hung by the nails on the wall.
Figure 5-1
Wall-mount installation
Step 4
Check by slightly shaking the device whether it is firmly installed on the
wall.
Summary of Contents for ISCOM HT803G-V (T)
Page 1: ...ISCOM HT803G V T UserManual www raisecom com ...
Page 6: ...6 4 LEDs ...
