Raise3D E2_Quick Start Guide
www.raise3d.com
-
11
-
Precaution and Hardware Installation
⚫
Read the entire installation section before starting installation
Connect equipment to a grounded facility power source. Do not defeat or bypass the ground lead.
• Know the locat
ion of equipment branch circuit interrupters or circuit breakers and how to turn them
on and off in case of emergency.
• Know the location of fire extinguishers and how to use them. Use only ABC type extinguishers on
electrical fires.
• Know local procedur
es for first aid and emergency assistance at the customer facility.
• Use adequate lighting for the equipmen
t.
• Maintain the recommended range of temperature and humi
dity in the equipment area.
• Do not use this product in an environment containing volati
le or flammable compounds.
⚫
Environmental requirements
• E2 is for indoor use only.
• Excessive solids
(conductive or non-conductive) in the air may cause system damage.
• The accumulation of oil in the air can damage the plastic parts of the printer.
• Th
e operating temperature should be in the range of 15°C to 30°C, with a relative humidity range of 10% to 90%
without condensation. The storage temperature shall be in the range of -25°C to 55°C, and the relative humidity
range shall be 10% to 90% non-condensation.
• The altitude shall not exceed 2,000 meters.
• Noise (Acoustics) : <50dB(A) during printing
NOTE:
E2 printers may generate vibrations which depend mainly on the geometry of parts being printed and
material characteristics. This will need to be taken into account if locating the printer near vibration sensitive
equipment.
Please note that during transportation in low temperatures, there is a chance the machine may frost
or freeze. The printer can resume use after being kept 4 - 6 hours in an area that is room temperature.
⚫
Input supply connection and grounding
During installation, the main outlet socket should be protected according to appropriate rules. Check the input
voltage, phase, and frequency supplied to this machine before turning it on. Verify the connection of grounding
wires from the machine to the input source. The allowable input voltages are 1x (90-240)V 50Hz/60Hz. For more
information about input supply refer to the technical specification section of this manual and to the rating plate of
the machine. Make sure the amount of power available from the input connection is adequate for normal
operation of the machine.
WARNING