(
)
|
|
The installation of the new extruder also requires that the stepper driver is adjusted. The current
motors are smaller and require lower current than the original motors. Without this adjustment,
there is a risk that the motors can overheat and become damaged.
To complete this adjustment, you will need:
-A Multimeter
-A Hex Wrench or Flathead Screwdriver
Summary of Contents for Bondtech Dual Extruder
