RAIS 800, Instructions For Installation, Use And Maintenance Manual, Page: 11 / 32

ENGLISH RAIS ­ manual for Rais 800
11
Installation of stove:
NOTE ! A decision must be made concerning the positioning of the inlets and outlets
of the convection system. Discolouration of the wall above the doors and the
convection air outlets may occur due to convected hot air.
RAIS cannot take responsibility for any building work or consequential
damage.
The stove should be inspected for defects at receipt.
Lift the stove from the pallet to the place of installation on to a suitably protected floor.
The stove can be mounted on the optional adjustable stand ( see page 29 ).
These are available to order from your local Rais dealer / stockist.
Using a spirit level against the door and body of the stove, ensure that the stove is
perfectly level and make adjustments using the levelling bolts in the base.
Remove door from the stove. Be careful not to damage the glass or paint.
Seal the flue pipe on to the flue outlet using fire cement and self tapping screws and
connect to the chimney.
Install the fresh air inlet connection to the pipe stub, if required.
The stove is now ready to be built in using either stud walls or solid walls.
When the walls have been finished and decorated, the door can be re­fitted.
Remove all protective plastic and tape prior to commissioning.
Made to measure frames are available to order with the stove from your Rais dealer /
stockist.