Assembly
3
. Place the first container on
the Plinth (it will only fit one
way) and assemble a bung on
the same side as the Outlet
Tube as shown. Turning the
Retainer ring in a clockwise
direction will pull the sealing
ring into place. Make sure you
stop the bung rotating from the
outside.
1
. Lay the Plinth on its back as
shown, assemble the Outlet Tube
(12) to the spigot on the underside
of the Plinth as far as it will go and
feed the other end through the hole
nearest to your Drainpipe
. (You can
soften the end of the pipe in warm
water to make it easier to fit)
2
. Position the Plinth on the flat base
about 2cm from the wall. The outlet
tube can be cut to length later when
you are ready to connect to the
Drain.
4
. Take one of the Drain-tubes and,
making sure the tap is closed, hook it
onto its holster. Insert the other end
into the hole on the container and fix it
in place using a Retainer Ring as
described above.
BUNG
RETAINER
RING
Drain-tube
3
Holster
