12.
Install the Brine Line
• Slide the brass compression nut over the end of the brine line,
followed by the ferrule and tube support. Attach the brine line to
the brass fitting on the right side of the valve (see figure 7).
• Insert a tube support into the other end of the brine line and
push the brine line into the brine safety float elbow. Use a
locking clip to secure the connection (see figure 7).
13.
Install the Brine Overflow Line
• Run a 1/2 inch brine overflow line from the overflow elbow on
the side of the brink tank to an approved air gap device and suitable
floor drain. Use a drain clip to secure the connection (see figure 7).
14.
Attach the Electrical Connection
• Remove the supplied wire from the warranty pack.
• Attach the U shaped connectors (supplied) to the wire with a
crimping tool (not supplied).
• Connect the wire to the transformer (see figure 8).
• Insert the other end of the wire, with the connector, into the
back of the control box (see figure 8).
• Plug the transformer into a 110 VAC 60 Hz or 230 VAC 50 Hz
outlet.
11
!
Important
Note
for
EC4-CAB
Models: The overflow elbow is
located on the back of the brine
tank (not shown).
!
Important Note: The brine overflow
line must not be higher than the
overflow elbow on the brink tank.
(This is a gravity overflow.)
Figure 7
Helpful Tip: Check the transformer
label for the correct voltage
requirement.
Helpful Tip: If the wire is too short,
use the supplied connectors and
shrink tubing in the warranty pack
to lengthen the wire.
Helpful Tip: Squeeze the connector
to release it from the box.
Figure 8
!
Important Note: Not Applicable for
EC4-CAB Models.
