Appendix 2 - Installation Instructions
– Page 4
7.
Mount the prefilter bracket as close to the
PSU as possible, not exceeding two meters
(six feet). Before installing the prefilter,
consider how you will run the tubing to
the
‘IN’
and
‘OUT’
sides of the prefilter. It
is very important that the tube from the
brass lift pump runs to the
“IN”
side and
the tube from the
“OUT”
side runs to the
high pressure pump. Note that the screws
mounting the bracket to the wall are
larger than the ones mounting the
housing to the bracket.
8.
Using the white
½”
tube supplied, connect the
‘IN’
side of the prefilter to the corresponding fitting on
brass lift pump on the PSU. Now connect the
‘OUT’
side to the push fitting on the side of the high
pressure pump.
