Rain Bird EZ1-D Programming Instructions Manual Download Page 7

7

IN CASE OF TROUBLE, CHECK HERE

Sometimes when problems occur, they can be easily solved by carefully checking
some seemingly apparent, but often overlooked possibilities. Check here before you
call your professional contractor or Rain Bird distributor. It could save you time and
money.

IF YOU'RE HAVING THIS KIND OF

TROUBLE

CHECK THESE THINGS:

 • Automatic cycle does not occur

 • If display is blank, check fuse in EZ1.

 • If last digit blinks, EZ1 is in the Rain Shut-
   Down mode.

 • Entire display is blank

 • Check fuse in EZ1; it probably needs replace-
   ment.

 • Entire display blinks

 • 9V battery needs replacing. After new battery
   is installed, reprogram controller.

 • Last digit in display blinks

 • EZ1 is in the Rain Shut-Down mode.

 • Last two digits in display blink

 • EZ1 is counting down the time remaining on
   station currently in operation.

 • Clock loses (gains) a few minutes
   every week or month

 • Intermittent power fluctuations are most likely
   responsible. Simply reset clock to correct time.

 • Fuse blows too often (display goes
   blank)

 • There is a short in the wiring between the
   controller and the valves.

   Have bare wires, non-water tight connections,
   and/or bad valve solenoids replaced.

Customer Support Center 

u

u

 6640 S. Bonney Ave. 

u

u

 Tucson, AZ  85706

1-800-RAIN-BIRD 

u

u

 (520) 434-6289

 

FAX

WARNING:

 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause interference to radio communications. However, there is no guarantee that interference will not occur in a particular installa-
tion.

If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:

• 

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and receiver.

• 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• 

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Rain Bird Sales, Inc.  could void the user’s authority to operate the equipment.

This product was FCC certified under test conditions that included the use of shielded I/O cables and connectors between system com-
ponents. To be in compliance with FCC regulations, the user must use shielded cables and connectors to install them properly.

Summary of Contents for EZ1-D








Reviews: