8. Advanced Output Methods
Rain Bird
®
ET Manager Series - Installation and Operation Manual
56
The processes of mounting, grounding, and connecting
the power source are the same as the Enable Output
Method. Complete the following steps to install your
ET Manager using the ET and Rain Pulse Output
Method:
1. You
MUST
remove the jumper wire connecting
the “Jumper” terminals.
2. Connect two wires from the ET pulse sensor
input from the sprinkler controller to the NOA
and A terminals on the ET Manager.
3. Connect two wires from the rain pulse sensor
input from the sprinkler controller to the NOB
and B terminals on the ET Manager.
ET Manager Programming using ET
and Rain Pulse
There are several settings that must be correctly pro-
grammed in your ET Manager. These settings are dif-
ferent for each sprinkler controller. Check the input
requirements of the sprinkler controller before pro-
gramming your ET Manager. The following settings
need to be made:
1. The Output Method must be set to ET & Rain
Pulse.
Main Menu
Settings
System
Output Method
ET & Rain Pulse
Wiring ET and Rain Pulse
Figure 16. ET Manager Terminal Connections ET and Rain Pulse