Caring For Your C-TUG® Cart
Thanks for purchasing a Quality, New Zealand Made C-TUG Cart.
The C-TUG is designed for the movement of watercraft. It is specifically not designed for the
movement of people either directly on the cart, or in or on watercraft or other objects placed on
the cart.
Due to the harsh and abusive environment where this product may be used, we suggest the
following steps be taken to extend the life of your C-TUG;
• After using your C-TUG in salt water, or sandy/dusty conditions remove the wheels,
disassemble the chassis and hose down with fresh water. Wash the axle area thoroughly.
• Do not clean with solvents or solvent based products, and avoid commercial
cleaning products, fresh water is best for cleaning C-TUG components.
• When portaging in hot, dry or dusty conditions it is recommended that you spray
axles with water regularly to avoid overheating in the axle area.
• Each time you fit the wheels to your C-TUG ensure the axle is clean and free of sand or debris.
• Do not leave your C-TUG cart in strong sunlight for extended periods. Your C-TUG
is designed for use outdoors but both rubber and thermoplastics will degrade if
left in strong sunlight for long periods.
Your C-TUG Cart is a robust, quality product designed to take the hard work out of getting your
watercraft to and from the water. With reasonable care you can expect it to serve you well for
many years. There is a 2 year warranty against manufacturing defects on the SandTrakz wheels,
and a 5 year warranty against manufacturing defects on standard Kiwi wheels and all other
parts. Please refer to our website www.c-tug.com for more details and information on how to
make a warranty claim.
NOTE:
Load should not be stored for long periods on SandTrakz wheels. Wheels must be
washed to remove sand from axle area after each use.
C-TUG encourages users of C-TUG products to observe safe practice procedures when using
products in marine environments.
®
All-Terrain
1. Thread ladder lock onto strap
2. Thread strap through hull pad
3. Feed strap back through
ladder lock
Part List:
• 2 x Crossbeams
• 2 x Hull Pads
• 2 x Wheels
• 1 x Kickstand
• 1 x Strap Kit (includes)
1 x 1.2 m Webbing
2 x Ladder Lock
1 x 1.6 m Webbing (with sewn on metal buckle).
www.ctug.com
Disclaimer: C-Tug is not responsible for injury or damage to
persons or property resulting from the misuse of this product.
MADE IN NEW ZEALAND
DIRECTION OF
PULL
Place the Kickstand at the back of
the kayak to ensure it folds away if
it hits an object.
Whether you place your
C-Tug at the front of back of
your kayak, dinghy or small
boat, always make sure the
Kickstand is opposite of the
pulling direction, i.e. behind
the cart.
USE KICKSTAND
OPPOSITE TO
PULL DIRECTION
© 2022 RAILBLAZA LIMITED, Auckland NZ, and RAILBLAZA USA (Railblaza) All rights reserved.
Protected by one or more of the following: AU365455, EU003058817-001, UK9003058817001,
CH ZL201630136196.7, USD826,840, NZ515498, NZ711637, AU2016216693, EU16186088,
CH ZL2016107202380 and US and Int’l. Pats. Pend.
CT-1034.G
