RemovethefourPhillipsscrewsfromthechassisthenliftthebodyawayfromthechassis.
STEP
small pipette of ProtoSmoke fluidisincluded). Do
not overfill the unitorthefluidmayleakoutandcoat
the interior engine components.
If youchoosenottoaddthefluid(orhavealready
added the fluid but choose torunsmoke-free),turnoff
the smoke unit switch located undertheenginebody.
When the smoke output while running the engine
begins todiminish,addanother 10-15 drops of smoke
fluid or turn thesmokeunitoff.
When storing the unit for long periods of time,
you may wanttoaddabout15dropsoffluidto
preventthe wick fromdryingout.
Afterremovingtheenginefromstorage, add
another 25dropsoffluid,letting the wicksoak
up the fluid for 15 minutes priortooperation.
If you experience poor or nosmokeoutput when the smoke
unit is onandhasfluid, check the wick to see if it has
become hard, blackened, and unabsorbent around the
heating element. Removetheboilerasshownbelow.
Remove the smoke unit inspection coverfromthe
locomotive's body (see right). After removing the chassis
and inspection cover screws, lift theinspectionplateaway
and inspect the wick. If it is darkly discolored andhard,it
should be replaced. When priming new wick add 40 drops.
!
!
!
Failure eithertoadd fluid to the unit or to turn it
off may damagethesmokeunitheatingelement
and/or wicking material.
Locomotive Light Bulb Replacement
!
To replace the light bulb in the locomotive,followtheboilerremovalinstructions below.
Wickin
Poor
Condition
Wickin
Good
Condition
Smoke Unit Cover
13
Running the engine without a primed
smoke unit may cause damage
Add15-20Drops
SmokeFluid
Add15-20Drops
SmokeFluid
SmokeUnit
ON/OFFSwitch
RailKing 6-8-6 Bantam Turbine Steam Freight Set with Loco-Sound™
