Raider RDP-HD31H, User Manual

Page: 14 / 78

14 www.raider.bg
drill bit centres itself upon drilling.
The dust protection cap largely prevents the entry of drilling dust into the tool holder during
operation. When inserting the tool, take care that the dust protection cap is not damaged.
4.3. Removing SDS-plus drilling tools. Push back the locking sleeve and remove the tool.
5. Inclusion and exclusion. Beware of the voltage of supply network! Supply voltage of the
network must conform to the details shown on the plate of power.
Appliances marked with 230 V, can be supplied with a voltage of 220 V.
5.1. To start the machine, press the On/Off switch.
5.2. To switch off the machine, release the On/Off switch.
5.3. Hammer drilling.
Warning!
When switching operation modes, Please trigger ON/OFF swich slightty.
1. Hammer drill mode:
Turn the mode selector witch 3 to , and turn switch 5 to the direction .
Figure 1
2. Chisel mode:
Turn the mode selector switch 3 to , and turn switch 5 to the direction.
Figure 2
3. Drill mode:
Turn the mode selector switch 3 to , and turn switch 5 to direction.
Figure 3
Place the switch the symbol “hammer drilling” Switch falls in the correct position with a
distinct twinge.
Long lasting drilling at low rotational speed of the spindle may cause motor overheating.
Make periodic breaks in operation. Do not cover holes for motor ventilation in the hammer drill
body.
It must be done to change the direction of rotation when the spindle rotates a drill!
5.3.1. When you need to vent large diameter, is recommended first to break a small opening,