Raider RD-SGC06, User Manual

Page: 16 / 80

16 www.raider.bg
Problem Cause Remedy
No coating material is coming
out of the nozzle
The nozzle is blocked
The ascending pipe is blocked
The small hole in the ascending pipe
is blocked
Material adjustment knob turned too
far to the (-)
The ascending pipe is loose
No pressure is built up in the
container
Clean
Clean
Clean
Turn to the (+)
Tighten pipe
Tighten container
The coating material drips from
the nozzle
The nozzle is loose
The nozzle is worn
Build up of coating material in the air
cap and nozzle
Tighten
Change
Clean
Spray too coarse Coating material has a too high
viscosity
Too much material
Material adjustment knob turned too
far to (+)
Nozzle dirty
Air filter very dirty
Not enough pressure built up in
container
Dilute
Turn material adjustment
knob to (-)
Clean
Change
Tighten container
The spray jet pulses Coating material in container is
running out
The small hole in the ascending pipe
is blocked
Air filter very dirty
Refill
Clean
Change
Run in the coating material Too much coating material applied Turn the material
adjustment knob to the (-)
Too much coating material mist
(overspray)
The distance to the object to be
sprayed is too large
Too much coating material applied
Reduce spraying distance
Turn material adjustment
knob to the (-)