Raider RD-OMT01, User Manual

Page: 16 / 84

16 www.raider.bg
holes in the hook & loop pad. b) Press the sandpaper firmly onto the hook & loop pad.
3. To remove the sandpaper, simply peel the sandpaper away from the hook & loop pad
(Fig. 4).
ON/OFF SWITCH
1. To turn the tool ON, slide the ON/OFF switch (1) toward the front of the tool.
2. To turn the tool OFF, slide the ON/OFF switch toward the rear of the tool.
! before the accessory reaches the workpiece, the tool should run at full speed
! before switching off the tool, you should lift it from the workpiece.
• Adjusting working speed
- with wheel F the required oscillating frequency can be adjusted from low to high (also
while tool is running)
- the optimal working speed depends on the material and can be determined with practical
trials.
• Holding and guiding the tool
! while working, always hold the tool at the grey-coloured grip area(s).
- keep ventilation slots uncovered.
- do not apply too much presssure on the tool (excessive pressure will cause excessive
heat and may shorten the service life of the accessory).
6. APPLICATION ADVICE
• Use segment saw blade for separating and plunge cuts in wood, plaster, gypsum and
plastics (also for sawing close to edges, in corners and other hard-toreach areas)
• Use plunge-cut saw blade for separating and deep plunge-cuts in wood, plaster, gypsum
and soft plastics (also for sawing close to edges, in corners and other hard-to-reach areas)
7. NOISE/VIBRATION
• Measured in accordance with EN 60745 the sound pressure level of this tool is 92 dB(A)
and the sound power level 103 dB(A) (standard deviation: 3 dB), and the vibration (hand-arm
method)
- when sanding 8.8 m/s² (uncertainty K = 1.5 m/s²)
- when cutting with plunge-cut saw blade 13.9 m/s² (uncertainty K = 1.5 m/s²)
- when cutting with segment saw blade 7.2 m/s² (uncertainty K = 1.5 m/s²)
• The vibration emission level has been measured in accordance with a standardised test
given in EN 60745; it may be used to compare one tool with another and as a preliminary
assessment of exposure to vibration when using the tool for the applications mentioned.
- using the tool for different applications, or with different or poorly maintained accessories,
may significantly increase the exposure level.
- the times when the tool is switched off or when it is running but not actually doing the job,
may significantly reduce the exposure level