12
www.raider.bg
Failure to do so could result in electric shock, fire and / or serious injury.
2. Functional description and purpose.
Brush cutter must only be used for cutting hedges and shrubs. Another use of the saw, not
included in this guide could damage the machine or seriously injure the operator.
3. Inclusion in the network.
This brush cutter can be connected only to a single-phase outlet. Make sure the mains voltage
is the same as the operating voltage on the plate.
4. Assembling Machine
- Install protective cover (2) on the machine frame, and pinch it tight on both sides with two
screws.
- Connect the plug with a suitable extension. Make a loop and shuffled through the hole in the
rear handle and hook retainer over the cable (6). We recommend using a residual current device
with tripping current 30 mA or less.
5. Turn on / off
On: Press the switch on / off (4) which is located on the main handle and simultaneously press
the switch (3) which is mounted on the auxiliary handle with both hands.
- Off: release one of the circuit breakers (4) or (3).
- Brake knife blades immediately stops within 1 sec. This can cause a spark in the upper vents.
This is normal and will not harm you or the machine.
- Cutting hedges.
Before starting work, select branches with a diameter greater than 16 mm and cut by sawing.
Trapezoidal profile corresponds to the natural growth of plants and promotes optimal growing
bushes.
- To encourage dense growth of young hedges, only half of new shoots should be cut.
If a hedge has reached the desired height, new shoots can be completely removed.
Start trimming from the bottom of the bush to the top. Trim the top in your preferred form in a
straight horizontal shape, or a rounded roof.
If the blades are clogged or blocked, stop the engine, remove the battery and then remove the
object jammed the knife.
Attention! Metal barriers such as fences, etc., can damage the blades.
- Always observe to keep extension cord behind him and start cutting hedges from the point
closest to the power outlet.
6. Maintenance and service
- Before carrying out any checks or maintenance operations, disconnect the power supply.
- Check your machine regularly before starting work.
Damaged cutting blades must be repaired or replaced by a qualified technician before operating
the machine.
- Always clean the remnants of grass and shrubs on the cutting head using a brush and cloth.
- Apply the spray support on the knife to prevent rust.
- Put the knife guard before storing machine for a longer period of time.
- Keep vents in the motor housing clean.
- To clean the instrument, use only mild soap and a damp cloth to clean the instrument. Do not
immerse the instrument in water and wash it with a hose. Do not allow any liquid to enter inside it.
Do not clean with high pressure cleaner.
7. Environmental protection.
In view of environmental power tools, additional accessories and packaging must be
subjected to appropriate processing for reuse of the information contained in these
materials.
Do not dispose of household waste power tools! Under the EU Directive 2012/19EC on scrapped
electrical and electronic equipment and promoting law and national power tools, which can not be
used more, must be collected separately and be subjected to appropriate processing for recovery
of contained therein scrap.