Switching off:
Press the switch (1) briefly
Speed control:
Adjust the speed by pressing the switch(1). Pressing the switch deeper the
speed will be higher. Arriving the highest speed when the switch is pressed to the end.
Handle Stand Assembly:
Push the handle stand to the position "in"( see picture) to insert the gap on the handle in
the screw hole and then fix the screw 3. Do opposite to loose the handle from the body.
Replacing Carbon Brush:
Use flatheaded screwdriver to screw out the brush hold cover and fix the new brush in. Then
screw back the brush cover tightly.
Working With the Paint and Mortar Mixer
The mains plug must be disconnected before the mixing tool is changed.
The unit should be run at low speed before it is immersed in or removed from the mixture.
The speed should only be increased to maximum after it has been fully immersed in the
mixture, in order to ensure that motor is kept as cool as possible. The machine must be
moved around inside the mixing vessel during the mixing process. Continue the mixing
process until all of the mixing components have been processed. Always clean the mixer
after you have finished using it.
(Picture 3)
(Pcture 4)
26
