35
5.6. By clearing stroke stand firmly again.
5.7. Avoid the previously cut material during the return stroke. Always work at full throttle.
This reduces the risk of material wrapping around the blade.
5.8. Do not operate without mounted safety guard (6).
5.9. Never use the brush cutter higher than 76 cm above the ground.
6. Stop the engine. Reduce the engine speed with a throttle lever. Allow the engine to run
about 30 seconds, then stop the engine by switching off the ignition key 0 (Stop).
Always collect the grass clippings after you stop the engine and wait to stop the rotation
of the blade.
7. Maintenance. Periodic checks are needed and settings to keep the brush cutter in
optimal performance. Regular maintenance will prolong the life in.
WARNING! Before any maintenance work on brush cutter engine must be off!
7.1. The inspection and maintenance must be performed by authorized persons, unless
you have the appropriate tools and skills necessary to do so.
Please note that support is recommended under normal operating conditions. If using a
brush cutter under other circumstances, we recommend you consult your dealer.
7.2. Turn off the engine and remove spark plug cable before examination.
7.3. Let the engine and manifold to cool so as not to burn from the hot surfaces.
7.4. Wear protective gloves so not to cut of the sharp elements.
7.5. Clean grass stuck to the blade and smear it with grease.
7.6. Drain all fuel from the engine, where to store motor mowers for more than a month.
7.7. The items listed below must be an experienced professional service it if you do not
have the appropriate tools and training.
7.8. You should always vent to cool the engine to be clean and free. They are open on the
side of the launcher.
The contents of the table, shows the periods in which the planned maintenance work to be
done.
Chart support for the brush cutter
Period
Element
to check
Each time before
starting the Tiller
Once per month
or after 12 hours
of work
Once per month
or after 50 hours
of work
Once per month
of after 100 hours
of work
Once per month
of after 300 hours
of work
Check the air
filter
●
Clean the air filter
●
Check the spark
●
Replace the
gasoline hose
Each two years
7.9. Cleaning the air filter.
Do not use a brush cutter with dirty air filter or without air filter. The dust and small particles
that will suck the engine will shorten its operational life.
Remove the air filter. Clean the filter with solvent and allow to dry completely after cleaning.
Do not clean the air filter with flammable liquids, may occur because of fire or explosion under
certain conditions. Once you clean it, put the air filter back into place.
7.10. Keeping the spark plug.
The recommended type of spark plug is Champion RCJ7Y, NGK BPMR7A or NHSP LD
L8RTF. To ensure normal operation of the engine, the spark plug must have adequate distance
