Raider RD-EW05, User Manual

Page: 8 / 30

8 www.raider.bg
1.14. When loading a boat into a trailer without keel or side hull rollers, make sure the trailer is
submerged in the water when the boat is loaded by the winch. Attempting to drag the boat on to the
trailer while on land can cause winch failure and possible injury.
1.15. Never operate winch if cable shows any signs of weakening, is knotted or kinked.
1.16. Winch does not have a locking mechanism. Secure load after moving.
1.17. Do not cross over or under cable under load.
1.18. Do not move vehicle with cable extended and attached to load to pull it. The cable could
snap.
1.19. Use gloves while handling cable.
1.20. Apply blocks to vehicle when parked on an incline.
1.21. Re-spool cable properly.
1.22. Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, or extension cords.
1.23. Replacement parts and accessories. When servicing, use only identical replacement parts.
Use of any other parts will void the warranty. Only use accessories intended for use with this tool.
1.24. Do not operate tool if under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any
doubt, do not operate the tool.
Warning! The electric winch is designed for intermittent use only, and should not be used in a
constant duty application. The duration of the pulling job should be kept as short as possible. If the
winch motor becomes very hot to the touch, stop the winch and let it cool down for several minutes.
Never pull for more than one minute at or near the rated load. Do not maintain power to the winch if
the motor stalls.
2. Unpacking and Installation.
When unpacking, check it to make sure all parts are included.
2.1. Mount electric winch to the vehicle using cap screw, nut, flat washer and lock washer, all
provided.
If the provided hardware does not accommodate the installation, use suited bolts or higher with
tongue to 35 feet-lbs. It should be aligned and secured to a soil part of the vehicle (front or rear) where
the full rate load will be evenly distributed. Also remember that the winch is designed for horizontal
pull, not vertical.
2.2. Connect the red (positive) battery cable from the solenoid assembly to the closest screw-
down positive (+) terminal to the 12 volt battery.
Caution! Battery cables should not be drawn taut. Leave slack for some cable movement.
2.3. Connect the black (negative) battery cable from the solenoid assembly to the closest screw-
down negative (-) terminal to the 12 volt battery.
2.4. Test electric winch for proper operation. Refer to the operation section, below.
3. Operation.
3.1. Disengage the clutch by moving the Freewheeling clutch to the out position.
3.2. Grab the cable hook and pull the cable to the desired length, then attach to item being pulled.
Caution: always leave at least four turns of cable before continuing.
3.3. Reengage the clutch by moving the Freewheeling clutch to the “In” position.
3.4. Lift the female connector cover exposing the electrical switch connector.
3.5. Insert the switch connector onto the female connector.
3.6. While standing aside of the tow path, press and hold the red pushbutton on the Switch.
Press and hold the opposite pushbutton to reverse directions. Wait until the motor stops before
reversing directions.
3.7. When the towing is complete, remove the switch. Form the female connector and replace the
female connector cover.
4. Maintenance.
4.1. Lubrication. All moving parts within the electric winch have been lubricated using high
temperature lithium grease at the factory. No internal lubrication is required.
4.2. Lubricate cable assembly periodically using a light penetrating oil.
4.3. Cable assembly replacement.