Raider RD-ETC25, User Manual

Page: 13 / 60

13
● Open the access cover of the blade guard
by removing the two securing screws.
● Remove the locking arbor bolt using the
hexagonal spanner while holding the outer
flange in place with the holding spanner
● Remove the outer flange, then the saw
blade
● When fitting the new blade, the rotational
arrow on the blade must point in the same
direction as that marked on the blade cover.
● Inspect the new saw blade for visible
damage. In the event it is damaged, replace it
immediately.
● Re-fit the outer flange, and then tighten the
locking arbor bolt firmly using spanners.
● Re-fit the access cover of the blade guard.
Note: Use only 180x22.2x2.2mm wet type or
turbo type blades specifically designed for tile
cutting. Do not use any blade rated for less than
2950 rpm.
8. Functions and characteristics
The mitre gauge on the table can turn to any
angle between 0º to 45º for diagonal cutting. In
the process of cutting, the pump will provide the
blade with water which can help to extend the life
of the blade and also reduce dust.
An internal thermostat has been provided to
maintain the motor temperature within normal
operating ranges. In case the motor is over
loaded, gets too hot or the current is too high, the
internal thermostat will automatically cut off. If this
happens, turn the switch off and wait 5 minutes
until the motor has cooled down to restart the
machine by on/off switch again. This feature
helps to protect the motor from damage due to
overheating.
9. Maintenance
WARNING! When servicing, use only identical
replacement parts. Use of any other parts may
create a hazard or cause product damage.
Do not attempt to make any adjustments while
the machine is in operation.
Always remove the electric power cord
from the power supply before changing parts,
lubricating the machine or when working on the
unit to avoid possible serious injury.
Keep the machine clean from accumulated
dust.
10. Cleaning:
Keep the ventilation slots of the machine clean
to prevent overheating of the motor. Regularly
clean the machine housing with a soft cloth,
preferable after each use. Keep the ventilation
slot free from dust and dirt. If the dirt does not
come off use a soft cloth moistened with soapy
water.
Never use solvents such as petrol, alcohol,
ammonia water, etc. these solvents may damage
the plastic parts.
11. DISPOSAL.
The machine, accessories and
packaging should be sorted for
environmental-friendly recycling.
The plastic components are labelled for
categorized recycling. Do not dispose of power
tools into household waste! According the
European Guideline 2002/96/EC for Waste
Electrical and Electronic Equipment and its
implementation into national right, power tools
that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.