Raider RD-ET02, User Manual

Page: 10 / 76

10 www.raider.bg
Before operation, read the operating instruction and follow the safety instructions.
Important!
When using equipment, a few safety precautions must be observed to avoid injuries and
damage. Please read the complete operating manual with due care. Keep this manual in
a safe place, so that the information is available at all times. If you give the equipment to
any other person, give them these operating instructions as well. We accept no liability for damage
or accidents which arise due to non-observance of these instructions and the safety information.
1. SAFETY INFORMATION
• Do not allow children or people unfamiliar with the instructions to use the tiller. Persons under
16 should not use it .
• The power cord must be unplugged before the inspection , repair or service activities.
• handling the cutter liable to third parties for damages caused during the operation of this
machine .
• Work only in daylight or ensure adequate artificial lighting.
• Always check the appliance for damage.
• Check to make sure that all safety devices are installed and functioning properly.
• Never use the machine if you are tired .
• Never use the appliance in a confined or poorly ventilated areas or in close proximity to
flammable or explosive liquids, gases or vapors.
• Stop the engine and disconnect the plug from the mains before removing the blocking or
blocked items before checking, cleaning or service in the event that you encounter a foreign body .
• Before use, you should check that are not worn or damaged cutting tools , fastening bolts and
all the cutting device.
• Damaged parts of the unit must be replaced by a specialist. We only use original spare parts.
• When installing or removing the blade to follow instructions and to use protective gloves .
• Check the area on which the router will be used and remove all objects which can be placed
in it and cause blockage . Before milling to remove foreign bodies . Notice of extension cords that
will be needed at work.
• When using a router , you must be a sturdy shoes and long pants . Never work barefoot or in
sandals.
• When starting the engine cutter should not be raised.
• Never place hands or feet under rotating parts .
• There must be a safe distance determined by the length of the handle.
• If you are working on sloping ground should be milled across the slope .
• Do not use cutter on terrain with slopes over 15%.
• Before you lift the cutter to transport it , you need to cut power to release the connection cable
and wait for stopping knife.
• Be careful at work near the router no people, especially small children or animals. Take care of
the small distance to work safely is 10 m
• Store the cutter in a dry place inaccessible to children.
• Electrical parts of the router should be repaired by a specialist .
• Only use extension cables must have a cross -section of at least 1.5 mm2 . Plug connections
have to wear contacts, and the joints are reserved by the water spray. Extension wire must go
through the handle and reach combination switch plug . Before using the wire check it for damage.
Never operate if wires are not perfect . If during work breaks conductor , immediately unplug the
unit and then check what the defect.
• When starting the engine cutter must not be tilted and turned .
• If the router begins to vibrate abnormally strong now have to be carried out.
• Make sure all nuts, bolts and screws are always properly tightened and the appliance is in
good working condition.
• If you encounter a foreign body , immediately turn off the engine and check the router for
damage and make necessary repairs before you start it again.