Raider RD-ESH02, User Manual

Page: 22 / 86

22 www.raider.bg
14.1. GENERAL CLEANING AND MAINTENANCE
Never spray the product with water or expose it to water.
Keep the unit, wheels and vents clean. Only clean with a brush or a soft cloth and never use harsh
cleaning agents or solvents.
Check that all nuts, bolts and screws are tightened.
Check the covers and protective equipment for damage and proper installation. Replace them if
necessary.
Keep the device in a dry place and out of the reach of children.
Do not cover the device with non-breathable material as it may cause moisture.
14.2. CLEANING CLEANING
1. Press the knob and remove the plug. Rotate the knob until the housing cover is released and lift
the housing cover.
2. Remove any objects blocking the machine and clean the inside of the cabinet if necessary.
3. Close the housing cover and tighten it by tightening the knob.
15. FAULTS AND WAYS TO REMEDY THEM.
The table below shows the symptoms of a malfunction and how you can help yourself if your crusher
stops working properly. If you cannot find and correct the problem by following the instructions in the
table, contact an authorized RAIDER service center. Attention! Before starting the troubleshooting, stop
the branch crusher and unplug it.
Faults Reasons Removal
The machine does
not work
The locking screw is not fully
tightened
Tighten the securing screw
Power is off Turn on the power
Network contact is defective Check the network contact
The extension cable is damaged Check the cable. Replace if damaged
The shredding
material is not pulled
The material is too soft Use a plunger or add dry branches
Clogged material Remove the clogged material
Excessive vibration
/noise/
Loose blade bolt Tighten the blade bolt
The cutting knife is damaged Replace the knife
Internal damage to the machine Check with an authorized service center
WARNING! Faults that cannot be solved with the help of this table can be solved by an authorized
service center.
If necessary, it is best to repair your crusher only by a qualified RAIDER repair shop where only
original spare parts are used. This ensures their safe operation.
16. ENVIRONMENTAL PROTECTION.
Do not dispose of used electrical equipment in the household waste! In order to protect
the environment and in accordance with Directive 2012/19 / EC, they must be collected
separately and subjected to appropriate processing for the recovery of the valuable raw
materials contained therein.