Raider Pro RDP-WP25, Instruction Manual

Page: 31 / 62

31
Ordering replacement parts:
Please quote the following data when order -
ing replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part
required
Environmental protection.
In order to protect the environment power
tool, accessories and packaging should
be subjected to an appropriate treatment
for the reuse of the information contained
therein.
Do not dispose of power tools into house -
hold waste! According to the EU Directive
2012/19 / EC on waste electrical and elec -
tronic devices and and establishment as a
national law power tools that can be used
more should be collected separately and to
be subjected to an appropriate treatment for
recovery contained therein scrap.
Troubleshooting guide
Faults Cause Remedy
The equipment
does not start
- Power supply not connected
- Floating switch does trigger
- Check power supply
- Raise position of floating
switch
The equipment
does not pump
- Intake sieve clogged
- Discharge hose kinked
- Clean intake sieve with
water jet
- Unkink the hose
The equipment
does not cut out
- Floating switch cannot sink - Place equipment correctly
on shaft bottom
Insufficient
pumping rate
- Intake sieve clogged
- Performance reduced due
to heavily contaminated and
abrasive water impurities
- Clean intake sieve
- Clean equipment and re -
place wear parts
The equipment
switches off after
briefly running
-- Motor circuit-breaker
switches the equipment off
due to excessive water con -
tamination
- Water temperature too high;
motor circuit-breaker switch -
es the equipment off
- Unplug power plug and
clean equipment and shaft
- Ensure that maximum
permissible water tempera -
ture (35 °C) is not exceeded