13
II. Intend use.
Coating Materials Suitable for use.
Water - and solvent - based paints, finishes, primers, 2-component paints, clear finishes,
automotive finishes, staining sealers and wood sealer-preservatives.
Wear hearing protection while operating the power tool.
The declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning.
The vibration emission during actual use of the power tool can differ from the declared total
value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an
estimation of exposure in the actual conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is switched off and when it is running idle in
addition to the trigger time).
III. Use.
1. Preparing the Coating Material
The paints usually need to be diluted for use with the spray gun. Since information on sprayable
dilutions is seldom given on the material tin, you can use the guidelines in the viscosity table
(viscosity = consistency of the coating material).
Example of material
DIN-s
Water based paints
20-25 sec
Oil Based paints
15-25 sec
Enamel paints
15-25 sec
Wood treatments
no dilution
Primers
20-30 sec
Varnishes
20-25 sec
Aluminium Paints
15-25 sec
Measuring the Viscosity.
Stir the coating material thoroughly before measuring.
Dip the viscosity test cup completely into the coating material.
Hold the test cup up and measure the time in seconds until the liquid empties out.
Note: This time is called “Runout Time in Seconds” (DIN-s).
2. Start-up.
Before connecting to the mains supply, be sure that the supply voltage is identical with the
value given on the rating plate.
Mounting air hose. Insert the air hose tightly in connections on the machine and the spray gun.
The connections can be positioned as desired.
3. Unscrew the container from the spray gun.
4. Aligning suction tube .The container contents are to be sprayed out almost completely.
