Rage X-Fly VTOL, Instruction Manual

Page: 3 / 6

Use a screwdriver to open the battery compartment. Then insert
three AAA batteries, matching the polarities (+ and -) marked
inside. Use alkaline batteries for optimal performance. Replace
the cover and screw it in place.
.
Install Transmitter Batteries
Install Flight Battery
1. Remove the battery cover.
2. Plug fully charged Lipo flight battery into the connector
3. Fit the battery into the compartment.
4. Reinstall the battery cover.
Controller Instructions
1. Press the On/Off button on the controller to turn it on.Press and hold the power button on the X-Fly until
the LED lights are blinking. Move the left stick up till you hear a beep, then move it all the way down until
you hear another beep.Now the controller is paired with the X-Fly and the lights will no longer blink.
2. After pairing, with the X-Fly on the ground, press the Take Off/Land button or move the left stick up to
take off. To avoid ground effect turbulence, ascend to at least 1’ (30cm) from the ground. Press the Take
Off/Land button again and the X-Fly will slowly descend, land and turn the motors off.
3. Push the left stick up to ascend, push the left stick down to descend. Push the left stick left/right to
rotate.
4. Push the right stick up to move forward, push the right stick down to move backward. Push the right
stick left/right to move left or right.