Rage RGRA1109, Instruction Manual

Page: 6 / 12

6
Right rudder trim button. This
button is pressed and held during
all servo reversing steps.
Please Note: This is a step that should not be required. It is included in the event that
a servo has become reversed and needs to be changed. Always check the direction of
travel of the control surfaces as part of your preflight safety check before every flight.
Servo Reversing
PLEASE NOTE: Install the 4 supplied AA batteries into the battery compartment
located on the back of the transmitter, under the battery hatch cover. Make sure
that the batteries are installed with correct polarity per the diagram inside the
battery compartment.
Elevator Trim
Aileron Trim
Charge Indicator Light
Antenna
Flight Battery
Charge Plug
Throttle/Rudder Stick
Rudder Trim
Throttle Trim
Power Switch
Power Light
Aileron/Elevator
Stick
Handle
Retract Switch
Transmitter Details
The Staggerwing transmitter features servo reversing on the rudder, elevator, and aileron
channels. The servo direction was set correctly at the factory for the Staggerwing. However, in
case any of the controls are operating in the wrong direction or you use the electronics in other
models later on, please follow these steps to change the servo directions as needed. Complete
all steps with the transmitter and aircraft powered on.
Rudder Channel Servo Reversing
Press and hold the right rudder trim button, then press the
left rudder trim button. Release both buttons and the servo
direction will be reversed. Repeat to change back.
Elevator Channel Servo Reversing
Press and hold the right rudder trim button, then press the
down elevator (top) trim button. Release both buttons and
the servo direction will be reversed. Repeat to change back.
Aileron Channel Servo Reversing
Press and hold the right rudder trim button, then press the
right aileron trim button. Release both buttons and the servo
direction will be reversed. Repeat to change back.