90°
Remove the pre-tightened set screws of the handlebar end cover using 4mm socket head wrench
Place the handlebar, adjust it to a suitable angle, close the end cover of the handlebar and pre-tighten 4 screws
using 4mm socket head wrench
Tighten set screws of the handlebar end cover in the order of 1, 2, 3 and 4
Align the f ront disc at the space of the gateway lining, align the front axle at the f ront fork axle hole and insert it
into the hole
Install gaskets and cap nuts on both sides
Tighten cap nuts on both sides using 15mm open spanner
1 4
2
3
2. Installation Procedure
2.1 Handlebar Installation
2.2 Front Wheel Installation
04
