Radyne QAM256, Installation And Operation Manual

Page: 28 / 87

User Interfaces QAM256 Digital Video Modulator and Upconverter
4-12 TM077 - Rev. 4.0
Interface Controls Screen:
4.7 QAM256 Terminal Mode Control
‘Terminal Mode’ can be entered from the front panel by selecting ‘System’ and then ‘Control
Mode’ followed by ‘Terminal.’ The default settings for the terminal are as follows:
1. 19,200 Baud;
2. 8 Data bits;
3. 1 stop bit;
4. No parity.
The baud rate can be changed at the front panel by using the System>Baud Rate menu. The
new baud rate does not take effect until power to the unit has been recycled.
4.8 Sample Terminal Mode Control Screen Menus
The Terminal Control Mode is menu-driven as shown in the screen captures below. The
allowable values for each item number are shown. To change an item, type in its number
followed by <ENTER>. If the parameter to be changed requires a numeric value, enter the
number followed by <ENTER>. If the parameter is non-numeric, press <SPACE> to cycle
through the list of available entries. Note that the items that do not have ID numbers are Status
only and cannot be changed.
Note: This feature has not been currently implemented.