RADLEY 1346-801, Owner'S Manual

Page: 10 / 18

9
POSITION OF THE TILE SAW
To avoid the possibility of the tool plug or outlet getting wet, position tile saw to one side of a wall-mounted outlet
to prevent water from dripping onto the outlet or plug. The operator should arrange a “drip loop” in the cord
connecting the saw to the outlet. The “drip loop” is that part of the cord below the level of the outlet, or the
connector if an extension cord is used, to prevent water traveling along the cord to run into the outlet.
If the plug or outlet does get wet, DO NOT unplug the cord. Disconnect the fuse or circuit breaker that supplies
power to the tool then unplug and examine for the presence of water in the outlet.
WARNING:
To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug with wet
hands.
1. On/off switch
2. Diamond cutting blade
3. Mitre cutting guide
4. Parallel guide fence
5. Water container
6. Blade guard/Splash Hood
7. Table tilting knob
8. Worktable
9. Parallel guide fence securing knob
10.Riving Knife
11.1x19 mm wrench
12.1x8mm wrench