Always use clean, dry, regulated, compressed air at 4.1 to 6.9bar (60-100PSI)
Do not exceed the maximum or minimum pressures. Operating the tool at the wrong
pressure (too low or too high) will cause excessive noise or rapid wear of tool.
1
18-gauge pneumatic brad
nailer
6
0 to 6.9 bar
2
Quick connector
7
Filter
3
Quick coupler
8
Cut-
off al e
4
Air hose
9
Air compressor
5
Lubricator
The use of any other types of fasteners will cause the tool to jam. Failure
to comply could lead to serious injury or loss of life.
It is recommended that a lter-regulator-lubricator is used and located as close to the tool as
possible.
If a lter-regulator-lubricator is not installed, place up to 6 drops of compressor oil into the
NPT inlet plug before each use.
If a lter-regulator-lubricator is installed, keep the air lter clean. A dirty lter will reduce the
air pressure to the tool, which will cause reduction in power,
efficienc ,
and general
performance.
For optimal performance, install a quick coupler in the hose, if applicable.
Verify that all of the connections in the air supply system are sealed in order to prevent air
from leaking.
