1280-009
8V CORDLESS MINI ROTARY TOOL KIT
10
UNPACKING AND SET-UP
CHANGING ACCESSORIES
1. Press and hold the spindle lock button.
2. Unscrew the collet nut and remove
completely with the supplied wrench.
3. Select a suitable collet for the accessory to
be used and insert, then cover with collet
nut.
(
Note:
The shipped machine is already fitted
with a collet of 1/8")
4. Lightly tighten the collet nut so that it stays
in place.
5. Insert shank of accessory into the collet.
6. Tighten collet nut using spindle lock and
wrench.
CAUTION:
It is recommended that no accessory
larger than 35mm (1.37”) in diameter should be
fitted to the rotary tool.
LOCATING A CUTTING/SANDING DISC
1. Remove the screw from the end of the mandrel with the wrench.
2. Fit the fibre flange on either side of the cutting/sanding disc, then insert the screw.
3. Tighten the cutting/sanding disc onto the cutting/sanding mandrel with the wrench.
NOTE:
DO NOT over tighten the screw as it could result in damage to the cutting disc.
LOCATING A SANDING BAND
1. Loosen the screw on the top of the sanding drum with the wrench.
2. Slide the sanding band onto the sanding drum.
3. Tighten the screw with the wrench until the sanding band is secured.
Summary of Contents for 1280-009
Page 18: ...17 ...
Page 19: ...1280 009 8V CORDLESS MINI ROTARY TOOL KIT 18 ...
