RADLEY 1262-300, Owner'S Manual

Page: 14 / 20

13
1 /
4
Sheet Sander - Owner's Manual
WARNING:
For safety reasons, the operator must
read the sections of this Owner’s Manual
entitled "GENERAL SAFETY WARNINGS",
"POWER TOOL SAFETY", "SPECIFIC
SAFETY RULES", "GUIDELINES FOR
EXTENSION CORDS" and "SYMBOLS"
before using this ¹/
4
sheet sander.
Verify the following every time the
¹/
4
sheet sander. is used:
1. Sander cord is not damaged.
2. Safety glasses and dust mask are
being worn.
3. Hearing protection is being worn.
4. Sandpaper is the correct type for the
job.
5. Sandpaper is in good condition and
is properly installed
Failure to observe these safety rules will
significantly increase the risk of injury.
WARNING: Always wear safety goggles
or safety glasses with side shields when
operating your sander. Failure to do so could
result in foreign objects being thrown into
your eyes resulting in possible serious eye
damage.
Always wear an appropriate dust mask
and hearing protection when using your
sander.
ON/OFF SWITCH
To turn the switch ON, press the right
hand side of the ON/OFF switch (1) (Fig.
6). To turn the switch OFF, press the left
hand side of the ON/OFF switch (2).
SANDING
Clamp or otherwise secure your workpiece
to prevent it from moving under the sander
while being sanded.
WARNING: An unsecured workpiece
could be thrown toward the operator
causing injury.
Place the sander on the workpiece so that
the complete sandpaper surface is in contact
with the workpiece. Turn the sander ON by
pressing on the side of the ON/OFF switch.
Move the sander slowly over workpiece
making successive passes in parallel lines,
circles or crosswise movements. Because
the orbital motion of the sanding pad moves
in tiny circles, it is not necessary to move
the sander with the grain or in the same
direction for successive passes (Fig. 7).
ASSEMBLY AND OPERATING
(continued)
Fig. 6
Fig. 7