O p e r a t i n g i n s t r u c t i o n s - B e l a l a t u s
ten
_ v 0 1 . d o c x
S e i t e
9
v o n
9
Operating instructions Radius belalatus® ten fan-
shaped awning
for end users
6
Troubleshooting
In case of an unexpected error, please follow the instructions below:
If the fan sail no longer reacts and you do not receive a display message on your
smartphone, then disconnect the system from the mains for approx. 15 seconds and
then switch the mains voltage on again.
Procedure for the following status information on the display:
Duty cycle reached:
Wait about 18 minutes.
Initialization necessary:
proceed according to initialization
G Driver overloaded:
Disconnect the system from the mains for approx. 15 seconds and reconnect it to
the mains.
Error Pulse direction wrong:
Disconnect the system from the mains for approx. 15 seconds and reconnect it to
the mains. If it still does not work, the Radius installer should be notified for
rectification.
If the current fails while the control inputs are active, it cannot be excluded that an
initialization must be done. For this purpose, the following procedure can be carried out
via the radio remote control (without app):
Press the "M" key 11 times in succession to activate the service mode. If no further
key is pressed, the control unit automatically switches off the service mode after 10
seconds.
In service mode, the following functions are now available via the radio handheld
transmitter:
a) 3 x "M" followed by "fan out" (fan opens) Initialisation force is switched off
b) 3 x 'M' followed by 'M1 Virtual limit switches are switched off
c) 3 x "M" followed by "M3" current position of all drives is stored as zero position
