Disable the Shelf Manager on the SCM
11
6. To determine the version of SCM’s on-board Shelf Manager, enter:
rsys_debug -h
7. After determining the version, enter the appropriate command.
8. Once the software tool has completed its initialization, the host address is displayed. Make a note
of this address for an upcoming step. Typically the address is located at either 0x82 or 0x84.
9. At the
cmd
prompt, enter
m
.
10. At the
menu
prompt, enter
40
.
11. The following prompt displays:
Set SCM ShMgr Mode -
Enter address (in hex):
Enter the host address you previously noted for
step 8
in hex format. For example, if the address
listed was
0x82
, enter
82
.
12. The following prompt displays:
Enter ShMC Mode (Enable 0, Disable 1):
Enter
1
to disable the on-board Shelf Manager. The
menu
prompt displays upon completion of the
process.
13. To verify the on-board Shelf Manager is disabled, enter
41
.
14. The following text displays:
Get SCM ShMgr Mode -
Enter address (in hex):
Enter the same host address you entered for
step 11
. If the on-board Shelf Manager is disabled,
this message displays:
SCM ShMgr Mode: Disabled
15. Enter
q
to exit the
rsys_debug
mode.
16. If a second SCM is installed, connect to it and run through the same set of procedures described in
steps
1
through
15
.
17. Cycle the power on the shelf to restart the non-RadiSys Shelf Manager.
18. Verify switch operation. See
page 7
for more information.
For version
Enter this command
Result
0.96 or below
rsys_debug
Takes you directly to IPMI serial interface.
0.97 or above
rsys_debug -i 127.1
Enables LAN access.
