RadiSys ATCA-5400 RTM, Reference

Page: 7 / 38

Electrostatic discharge
7
PICMG AMC.0 R2.0 Advanced Mezzanine Card Base Specification , PCI Industrial Computer
Manufacturers Group, November 15, 2006
PM8380 QuadSMX 3G Quad SATA/SAS Mux/Demux for 3G, PMC-2031101 , Issue 8, PMC-
Sierra, April 2005
Serial ATA Revision 2.5 , Serial ATA International Organization, October 27, 2005
Small Form-factor Pluggable (SFP) Transceiver Multisource Agreement (MSA), Cooperation
Agreement for Small Form-Factor Pluggable Transceivers
, Agilent Technologies, Blaze Network
Products, E2O Communications, Inc., ExceLight Communications, Finisar Corporation, Fujikura
Technology America Corp., Hitachi Cable, Infineon Technologies Corp., IBM Corp., Lucent
Technologies, Molex, Inc., Optical Communication Products, Inc., Picolight, Inc., Stratos
Lightwave, and Tyco Electronics, September 14, 2000
UL 60950-1 Safety for Information Technology Equipment – Part 1: General Requirements,
Edition 1
, Underwriter Laboratories ( www.ul.com ), April 1, 2003
Electrostatic discharge
W
ARNING
!
This product contains static-sensitive components and should be handled with care.
Failure to employ adequate anti-static measures can cause irreparable damage to components.
Electrostatic discharge (ESD) damage can result in partial or complete device failure,
performance degradation, or reduced operating life. To avoid ESD damage, the following
precautions are strongly recommended:

Keep each RTM in its ESD shielding bag until you are ready to install it.

Before touching the RTM, attach an ESD wrist strap to your wrist and connect its other end
to a known ground.

Handle the RTM only in an area that has its working surfaces, floor coverings, and chairs
connected to a known ground.

Hold the RTM only by its edge and mounting hardware. Avoid touching PCB components
and connector pins.
For further information on ESD, visit www.esda.org .