D9412G/D7412G Operation & Installation Guide
© 2002 Radionics
Page 61
43488D
D9412G/D7412G
Programmer and Accessory Connections
12.0 Programmer and Accessory Connections
12.1
Programmer Connector
The procedure below shows how to connect
and disconnect the programmer. Refer to
the
D5200 Operation Manual for complete
information on using the D5200
programmer.
1.
Lock Reset Pin: See Figure 21.
2.
Connect the D5200 Data/Power cord
into the programmer connector.
3.
Perform the desired programming
function (send or receive program).
4.
Disconnect the programmer.
12.1.1 Programmer Access Reports
When a program is sent to the panel, the
panel sends a
PROG ACCESS OK
report ten
seconds after the handler is exited or when
the programmer is disconnected. The
prompt in Routing must be programmed
YES for this report to be sent.
12.2
Accessory Connector
Use the Accessory Connector to connect
the panel to the D928 Dual Phone Line
Switcher. The Accessory Connector is on the
bottom right corner of the I/O board. See
Figure 22. The D928 allows the panel to use
two telephone lines to transmit reports.
See section
6.12 D928 Dual Phone Line
Switcher for installation and operating
instructions.
Reset Pin
Disable All Except Battery
Charging And Programming
PERIPHERAL DEVICE CONNECTIONS
RED
POWER +
YELLOW
DATA BUS A
GREEN
DATA BUS B
BLACK
COMMON
32
31
30
29
RESET PIN
LOCKED (CLOSED)
RESET PIN
NORMAL (OPEN)
FOR NORMAL
PANEL
OPERATION
Figure 21: Reset Pin
Figure 22: Programmer and Accessory Connections
Accessory
Connector
Programming
Connector
GRN
PROG
CONN
Point 8
GND FAULT
Detect
L
E
D
I
S
A
B
L
E
26
25
NEX IN 2
NEX POWER +
24
ZONEX COMMON
23
