Two signal working mode:
Blue/purple LED, SBUS signal, 10 channels totally.
Red LED always, PPM signal, 10 channels totally.
SBUS and PPM signal change:
Short press the ID SET switch twice within 1 second, the signal is changed from SBUS to PPM. The
red LED indicates the PPM and blue/purple indicates SBUS.
How to match code with transmitter:
1. Place the transmitter and the receiver close to each other within 1 meter.
2. Turn on the transmitter, then power on the R6DSM.
3. Connect R6DSM to ESC or flight controller or servo.
4. There is a black button on the R6DSM, press the binding button in one second until the
receiver light starts blinking and release, after about 8 times blinking, match code success when
receiver signal LED always on.
Installment of receiver antenna：
1. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.
2. Large model aircraft may of some metal part interfering signal, in this case the antenna should
be placed at side of the model.
3. The antenna must be kept away from conductive materials, such as metal and carbon by at
least a half inch. The coaxial part of the antenna does not need to follow these guidelines, but do
not bend it in a small radius.
4. Keep the antenna away from the motor, ESC, and other noise sources as much as possible.
5. The receiver can be packed by sponge or foam for shocking proof when it is installed to the
model.
After all of the above steps finished, now the program functions to assure it under control of
transmitter with a right connection.
Specification:
1. Channels: 10 channels
2. Working voltage: 4.8-6V
3. Working current: 38-45mA（input voltage: 5V）
4. Size: 15*13 MM
5. Weight: 1.5g
6. Detachable antenna
7. 4096 section precision, 0.25us per section, servo anti-shake rudder.
8. Control distance: about 600 meters, actually control distance depends on the environment.
